Читать книгу Boys' Make-at-Home Things онлайн

10 страница из 20

Diagrams of Work-bench Accessories.

The fifty-six-inch length which was not ripped in two is fitted at right angles to the back of this rack, lapping over the edge and flush with the top. It is nailed in position and two supporting brackets like Fig. 2 are fitted under each end of the rack for strength. When this is all fastened together, the whole rack is set up on top of the back pieces of the workbench and held in place by two cleats, three inches by eight which are screwed to both the back piece of the bench and the back piece of the rack.

Underneath the holes for the bits there should be two nails to hold the brace. The jack plane, block plane, and spoke shave may stand on the bench underneath the rack, and screws or nails at the end of the bench will hold rip saw, cross-cut saw, and dust brush.

Next in usefulness is the bench block shown in Fig. 3. For this cut one piece of wood six inches by eleven, and two pieces, six inches by two inches. All these pieces must have the grain running in the longest direction. When these are trued up, fit them together as shown, and fasten with one-and-three-quarter-inch wood screws. After completing this the corners are cut off. The block fits over the front edge of the bench near the right-hand end and forms a brace when one wants to hold a piece of wood steady for sawing.